Mining Submersible Pump

Product Description:

Mining Submersible Pump

QKD series Mining submersible pump

This kind of pump has the same parameters with that of QJ deep well submersible pump. after the technical modification of the company, to meet the actualneeds of industrial and mining environment, the specific structure to disclose; downdraft submersible pump, the biggest advantage is that it can lower the surface water discharge, stable performance, convenient installation.

Low suction mine submersible pump can be vertical, horizontal, use, better adapt to the mineunder complex environment; the traditional QJ series horizontal submersible pumps for, to mine under the water can not be discharged clean, not easy to work underground, new minesubmersible pump, mine water discharge can be higher than that of 0.01M well; Tianjin Aote pump is a manufacturing, R & D, innovation, sales in one of the modern enterprise, our company can be customized to adapt to different environment of mine submersible pump, there are special requirements please inform!

QKD series new mining submersible pump, applicable to the extraction of groundwater from deep well, mine, and can be used for gold, silver, iron ore, coal,construction site drainage emergency use. (flow per hour can reach 650 tons, lift of 1500 meters)

Low suction type submersible pump characteristics:

1, motor, pump body, into the water to run, no Mars, explosion-proof, safe and reliable.

2, the well pipe has no special requirements to the water pipe, as long as can bear the pressure can.

3, the installation is simple and convenient to use and maintenance, small occupation area,without the construction of pumping stations.

4, has the advantages of simple structure, raw material saving.

5, high efficiency, energy saving, single stage high lift, large flow, high lift, high efficiency and energy saving motor imported from Germany, such as: AT200QJ series submersible motor can be achieved 110KW (diameter is 184mm), the 2 levels of speed (2900/ minutes) can be done 410KW, minimum diameter can be done 134mm pump.

The use of the environment and requirement;

1, the power frequency 50Hz, rated voltage of 380V or 440V, 550V, 660V, 3KV, 6KV, 1140V or high pressure (tolerance + -5%) of the three-phase AC power supply.

2, the general non corrosive water.

3, solid content (by mass) of not more than 0.01%.

4, pumping liquid acid called pH value is 6.5-8.5.

5, the chlorine content of not more than 400mg/L.

6, the hydrogen sulfide content is not more than 1.5mg/L

7, the transmission medium temperature does not exceed 20 degrees.

8, the water inlet of the water pump must be in dynamic water level below LM, but the divingdepth of no more than the static water level to 70m, the electric pump at the lower end of off bottom water depth of at least lm.

Special lift, flow rate, voltage submersible pump: - flow range: 150m3/h ~ 2200 m3/h; - lift range: 100 ~ 1700m; - Power: 55kW~4000kW; - voltage: 380V, 660V, 1140V, 3kV, 6kV, 10kV.