Fiberglass Mat Tissue Sandwich Fabric Complex Mat 780g 200～2600 mm

◎ This mat is the multi-layered combination mat, generally made by mechanically stitching layers of roving or woven roving or chopped strand, in this case to one or both sides of synthetic fiber core (PP or PET), like a sandwich. The complex mat generally also be made from a combination of woven roving which are mechanically stitched with mats made of chopped strand to form the “bread”. Some complex mat even have no roving or fabric (i.e. complexes stitched from mats and veils without fabric layers). In all cases, the layers are mechanically stitched to the synthetic fiber core. It is mainly applied in the hand lay up, RTM and other close molding processes.
◎ This fabric is compatible with UP Resin, Vinyl ester resin, epoxy resin system etc. It is widely used in closed mould applications for vehicle bodies and panels, marine (boat hulls and decks), windmill nacelles, leisure vehicle and structural shapes.

◎3-D spacer fabric construction is a newly developed concept. The fabric surfaces are strongly connected to each other by the vertical pile fibers which are interwoven with the skins. Therefore, the 3-D spacer fabric can provide good skin-core debonding resistance, excellent durability and superior integrity. In addition, the interstitial space of the construction can be filled up with foams to provide synergistic support with vertical piles. These products have broad application prospects in automobile, Locomotives, aerospace, marine, windmills, building and other industries.

Products Traits

◎ The structure of sandwich to increase strength, reduce product weight and better surface finish.
◎ low resin-consumption and faster wet-out.
◎ Good manufacturability and mechanical properties
◎ Improved fatigue and impact resistance
◎ Good drapability for complicated shapes and good resin flow

General parameters:

Marine Applications

Structural:

·Bulkheads ·Decks ·Hulls of racing catamarans and ribs(RIBS)

Non structural:

·Fly-bridges ·Cabins ·Hatches ·Doors

Interior parts:

·Furniture ·Partitioning ·Floor and ceiling panels ·Sanitary Cabinets

Wind Power Applications

·Nacelles Cover ·Nose cone ·Blade

Chemical industry-Corrosion Applications

· The following double wall structures can be obtained using 3D fabric

·Double wall full GRP Tank ·Double wall tank lining

Building Applications

·Interior and exterior wall covers ·stone strengthen ·radar domes ·industrial roofing

·amusement parks ·exhibition panels ·kiosks ·lightweight rigid covers

Packing:

Each roll is wrapped by PE film and then packed into carton. Stacking in bulk or palletized is available; the pallet shall be no higher than 2 layers.