Fiberglass Multiaxial Fabric-UD 600gsm for wind power industry
Loading Port:Shanghai
Payment Terms:TT or LC
Min Order Qty:5000 kg
Supply Capability:100000 kg/month
Product Description:
Description & application
◎ This fabric is made of fiberglass roving which are aligned at 0° or 90° into one layer of roving by stitching together with or without one layer of chopped strand. It is mainly applied in the hand lay up, RTM and other close molding processes. ◎ This fabric is compatible with UP Resin, Vinyl ester resin, epoxy resin system etc. It widely used in nacelles and blades for wind power, boat hull, cases and shell of auto etc.
Feature:
◎ Small gap between fibers, Increased strength, reduced product weight and better surface finish. ◎ low resin-consumption and faster wet-out. ◎ Good manufacturability and mechanical properties ◎ Improved fatigue and impact resistance ◎ No binder
General parameters:
Code
Total weight g/m2
Weight of each layer, g/m2
Width mm
0°
90°
+45°
-45°
Chopping
E-L300
350
300
50
200～2600
E-L350
400
350
50
200～2600
E-L400
450
400
50
200～2600
E-L450
500
450
50
200～2600
E-L500
550
500
50
200～2600
E-L600
650
600
50
200～2600
E-L650
700
650
50
200～2600
E-L900
930
880
50
200～2600
E-L700/200
950
700
50
200
200～2600
E-T200
200
200
200～2600
E-T450
450
450
200～2600
E-T500
500
500
200～2600
E-TM300/300
600
300
300
200～2600
E-TM600/450
1050
600
450
200～2600
E-LM750/200
950
750
200
200～2600
Packing:
Each roll is wrapped by PE film and then packed into carton. Stacking in bulk or palletized is available; the pallet shall be no higher than 2 layers.
