Fiberglass Mat Tissue - Multiaxial Fabric-UD (0° or 90°) 300/50g

Description & application

◎ This fabric is made of fiberglass roving which are aligned at 0° or 90° into one layer of roving by stitching together with or without one layer of chopped strand. It is mainly applied in the hand lay up, RTM and other close molding processes.
◎ This fabric is compatible with UP Resin, Vinyl ester resin, epoxy resin system etc. It widely used in nacelles and blades for wind power, boat hull, cases and shell of auto etc.

Feature:

◎ Small gap between fibers, Increased strength, reduced product weight and better surface finish.
◎ low resin-consumption and faster wet-out.
◎ Good manufacturability and mechanical properties
◎ Improved fatigue and impact resistance
◎ No binder

General parameters:

Packing:

Each roll is wrapped by PE film and then packed into carton. Stacking in bulk or palletized is available; the pallet shall be no higher than 2 layers.