Fiberglass Mat Tissue - Multiaxial Fabric-UD (0°:700g, 90°:50g, Chopping:200g)

◎ This fabric is made of fiberglass roving which are aligned at 0° or 90° into one layer of roving by stitching together with or without one layer of chopped strand. It is mainly applied in the hand lay up, RTM and other close molding processes.
◎ It’s compatible with UP, Vinyl Ester and Epoxy etc, used in GRP pultrusion process, hand lay-up process and RTM process etc,out made products include GRP boats,automobile parts, wind energy blades etc.

Feature:

◎ Small gap between fibers, Increased strength, reduced product weight and better surface finish.
◎ low resin-consumption and faster wet-out.
◎ Good manufacturability and mechanical properties
◎ Improved fatigue and impact resistance
◎ No binder

◎ Mechanical property of different directions is adjustable.

◎The multi-layers structure could simplify forming process, improve operation efficiency.

General parameters:

Packing:

Each roll is wrapped by PE film and then packed into carton. Stacking in bulk or palletized is available; the pallet shall be no higher than 2 layers.