Egypt 6''8''10'' Deep Well Submersible Pump( Solar Pump )

Specifications

  Egypt 6''8''10'' Deep Well Submersible Pump( Solar Pump )

Our main products QJ submersible pumps series, QS bearing submersible pump series; QSL submersible halogen pumps series; WQ sewage pumps series; QY Oil Immerse submersible pump; SLG/SLW pipeline pump; D-Phase pumps; MD centrifugal pumps; SSQJ stainless steel deep well pumps, etc. over 40 kinds of series.

The pump flow range:   5m3/h~2000m3/h,

Lift scope :                   5m-1400m,

Motor power range:     0.55-500 kW.

There are over 3000 models.

SQJ ,SQS,SQY Submersible Pump Series Parameters

SQJ Submersible pumps Parameters:

Flow range10~500m3/h, Lift scope within 5~405m;

Caliber scope 32~203mm, Temperature range-15~80° C.

SQS Bearing submersible pumps Parameters:

Flow range10~250m3/h, Lift scope within 5~12m;

Caliber scope 30~150mm, Temperature range<=30° C.

SQY Oil Immersed submersible pumps Parameters:

Flow range10~100m3/h, Lift scope within 5~54m;

Caliber scope 51~152mm, Temperature range<=40° C.

Products Overview

SQJ, SQS, SQY, Series submersible pumps widely used in farmland irrigation, spray irrigation and water-use, industrial and civil buildings, also the drainage system to level hills, mountain diversion and in low-lying areas dunes, urban and rural mining supply, drainage and other water conservancy facilities. Characteristics are that they are assembled into a simple structure they have installation convenience a small footprint, simple maintenance and a safe reliable operation.

Product use conditions

1. SQJ Submersible pumps use conditions:

(1)380 V bias voltage does not exceed +/-10% and 50 HZ frequency, and the deviation is not more than + -1% of the three-phase power supply.

Electrical cavity must be filled with water during operation.

(3)The first-class pump impeller should at least go into a dynamic water level 2 m below surface. Static pump unit immersed under water shall not be greater than 70 m in depth.

(4)The normal water temperature should be no higher than 20 ° C, QJR- hot water pump temperature up to 80 ° C.

(5)Water and sand content (by mass) of not more than 0.01%.

(6)Water PH 6.5-8.5.

(7)The hydrogen sulfide in water content is not more than 1.5 mg / L.

2. SQS Bearing submersible pumps usage conditions:

(1)Power: 50 Hz frequency and voltage of 380 volts (allowing deviations +5% -10%) of the three-phase AC power. Pumps should be safe submerged operations, diving depth of not less than 0.5 meters.

(2)Water: general corrosion without water, sand volume is not 0.02%, PH: 6.5 ~ 8.5, extracting the water temperature no higher than 30 ° C.

3. SQY Oil Immersed submersible pumps use conditions:

Submersible pumps submerged depth of not more than 5 m; Water temperature does not exceed 40 ° C; water sediment or water insoluble solid mark of the volume ratio of not more than 0.1%, particle size less than 0.2mm, water pH value of 6.5 ~ 8.