Loading Port:Shenzhen
Payment Terms:L/C,T/T
Min Order Qty:1 Piece unit
Supply Capability:500 Pieces per Week unit/month
42 inch RS232/USB Controller IR Multi Touch Screen (Size10.4"-120")
Specification
MECHANICAL | |
P/N | CIL420-4K-T2-A |
Housing | Aluminum frame |
Touch panle size(mm) | 990.6*582.6 |
Active area(mm) | 936*528 |
TOUCH CHARACTERISTICS | |
Input Method | Finger or touch pen(Six points touch) |
Touch Activation Force | Non Minimum activation force |
Position Accuracy | 2mm |
Resolution | 4096(W)×4096(D) |
Response Time | Touch: 8ms |
Drawing : 8ms | |
Cursor Speed | 120 dot/sec |
Glass | No glass or 4mm glass,Transparence : 92% |
Optics Number | 156(W)×88(D) pcs |
Optics Cell Area | 6.0*9.0mm |
Object Touch Size | ≥ Ø5mm |
Touch Intensity | Over 60 millions single touch |
ELECTRICAL | |
Operating Voltage | DC 4.5V ~ DC 5.5V |
Power | 1.0W (200mA at DC 5V) |
Anti -Static Discharge (Standard :B) | Touch Discharge,Grade 2:Lab Vol 4KV |
Air Discharge,Grade 3:Lab Vol 8KV | |
ENVIRONMENT | |
Temperature | operating:-10 °C ~ 50 °C |
storage:-30°C ~ 60 °C | |
Humidity | operating:20% ~85% |
storage:0%~95% | |
Relative Humidity | 40 °C,90% RH |
Anti – glare Test | Incandescent lamp (220V,100W) , operating distance over 350mm |
Altitude | 3,000m |
Interface | USB2.0 full speed |
Detection Method | Infrared rays |
Seal Ability | IP65 |
Working Environment | Under sunlight ,indoor and outdoor |
Application of Display | LED,LCD,PDP |
Software(Firmware) | |
Scanning | Auto full screen scanning |
Touch Trigger | Drop,raise,move on plane |
Output | Coordinate output |
Install
A:IR Touch screen consists of four aluminum article,normally,the four aluminum article are connected,
and glued with the glass,for the convenience of transport and save shipping cost ,it also can
be separated when delivery.As you can see in the following graph 3.2a;
B:If the article aluminum alloy is separate,Assemble it according the step of 3.2b-3.2e. As follows step:
In Exhibit 3.2b,to pump PCB board from A1 port ,connect A2 port FPC to A1 port FPC socket:
Pay attention : FPC socket is very precise,At connection PFC cable time, please follow 3.2c-3.2 steps :
a. Pull out the card buckle: please push out the locked card buckle of FPC socket in direction of arrow ,
as 3.2c shown ;
b. Insert the FPC: Push A2port ribbon wire into FPC socket ,blue face up, as 3.2d shown ;
c. Lock the card buckle: push Card buckle of PFC socket in direction of arrow,as 3.2e shown;
FAQ:
Q1: Can dust damage electronics?
A: Dust and electronics do not make good friends. The thicker the layer of dust is on a
circuit board the more chance there is of a short depending on the nature of the dust.
Q2: Are electronics cheap in Okorder.com?
A: Of course. They are very cheap. The factories provide the goods. One-stop sourcing.
Q3: Why are electronics so cheap in ok order?
A: On ok order they are the lowest price. Because it is a wholesale website and factory
provide goods.
