Loading Port:China Main Port
Payment Terms:TT OR LC
Min Order Qty:-
Supply Capability:-
Product Information
Adhesive Reflector useSAE A and DOT approved reflex reflectors to reduce cost in your reflectorapplication program. These reflectors are easy to install, cannot be knockedoff like plastic reflectors, and save time with their quick peel & stickapplication. Our reflectors feature a highly reflective prismatic lenses in adurable transparent resin. The backing is coated with a permanent aggressivepressure sensitive adhesive with a clear poly easy remove liner.
· Low profile and not easily knockedoff
· Meets and exceeds DOT and SAE-Arequirements for reflex-reflectors
· Superior angularity beyond 60°
· Prismatic lenses in a durabletransparent synthetic resin
· Pressure sensitive adhesive and clearpoly liner
· More reflectors available in red,amber, round and rectangle styles
Specification
Adhesive Reflector | ||
Adhesive | Permanent pressure sensitive adhesive | |
Face Film | PMMA prismatic retro reflective film | |
Total Thickness | 19-22MIL | |
Liner | Clear poly liner | |
Tape Application: | Minimum application temperature 100C (500F) Surface must be clean, flat and free from dust, dirt, oil, wax, silicone. | |
Certification: | Reflectivity meets or exceeds SAE J592 A | |
Operational Temperature | Room Temperature | |
Shelf Life: | One year from date of purchase when stored at 700F, 50% relative humidity. | |
Size | 2"x3-1/2" |
|
Parameter
Warranted PhotometricPerformance: Minimum candlepower per incident foot candle for a reflexreflector.
Observation Angle | Entrance Angle | Red | Amber |
0.2 degree | 0 degree | 11 | 18 |
10 degree up | 9 | 15 | |
10 degree Down | 9 | 15 | |
20 degree Left | 7 | 11.5 | |
20 degree Right 7 | 11.5 | 17.5
| |
1.5 degree | 0 degree | 0.9 | 1.5 |
10 degree Up | 0.09 | 0.15 | |
10 degree Down | 0.09 | 0.15 | |
20 degree Left | 0.08 | 0. 13 | |
20 degree Right | 0.08 | 0.13 |
Colors& Specification Limits (Daytime)
The initial daytime(Illuminant A light source) color shall conform to the requirements identifiedin the table below. Tested in accordance to SAE J578 test method 4.1.3 45/0 (orequivalent 0/45) geometrics, CIE Illuminant A, and the 1931 CIE 2-degree standardobserver. Values are based off of calculations and are only estimates. Refer toSAE J578 for details
Color | 1x / 1y | 2x / 2y | 3x / 3y | 4x / 4y |
Red | 0.67 / 0.33 | 0.65 / 0.33 | 0.736 / 0.264 | 0.716 / 0.262 |
Amber | 0.61 / 0.39 | 0.597 / 0.39 | 0.545 / 0.425 | 0.56 / 0.44 |
Stick-on reflectors mountto any clean surface
Low profile – can’t beknocked off like
Molded reflectors
All reflectors marked
With SAE A DOT
Easy application and longterm durability
